|
The Swiss Piccard Eureka was designed to be an easily transportable single seat three-axis ultralight. Its development was brought to a halt by the Swiss ban on ultralight aircraft in 1984. ==Design and development== The Eureka was a small but conventionally laid out tractor configuration low-mid wing monoplane with an open cockpit and cruciform tail. It was formed from aluminium tubing with fabric covering. The wings were approximately semi-elliptical in plan and wire braced from above and below, with straight, unswept leading edges and curved trailing edges. The 2.05 m (6 ft 7 in) root chord reduced to pointed tips. Roll was controlled with wing warping from a conventional control column.〔 A 20 kW (27 hp) Rotax 277 single cylinder two-stroke engine in the nose at wing height drove a two-blade propeller, with the cockpit immediately behind. The pilot had a windscreen and behind him the seat back was faired into the short, thin fuselage section between the wing trailing edge and the tail. The vertical tail was kite shaped, with the longer triangular section above the wing and with the rest forming a short ventral fin. The whole rear section was hinged as a conventional rudder. The horizontal surfaces were each triangular and mounted on the fuselage, with the rear sections forming elevators.〔 The Eureka had a conventional fixed tail wheel undercarriage, with rubber suspended mainwheels on individual pairs of V-struts and linked by a cross axle. The tail wheel was held below the ventral fin on a long rearward strut from the fuselage. With wings and tail folded, the Eureka could be transported on the luggage rack of a medium sized saloon car.〔 The Eureka was first flown in the early 1980s but its testing development ended when the Swiss government completely banned ultralight flying on the basis of noise pollution. This ban on ultralights was not lifted until 2005.〔 Only one Eureka was ever built.〔 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Piccard Eureka」の詳細全文を読む スポンサード リンク
|